wont run long enough to fix

gotburnt

New member
I have replaced the distributor, cap, p/u, plugs, wires, starter. altenator. . tried to find dead zero on pulley, will not start w/out full throttle. then will not idle unless at 2000 rpms, got up to 4000 rpms and cuts back out? i have done a compression test and a fuel pressure test as well as replaced the fuel filter, rear main seal, valve cover gasket, oil pan gasket and oil filter. should the mark be before 0 on 0 or after 0. also i cannot find the PCV valve. this may be contributing to my problem?:cry: can u please help me. I have had this jeep registered and insured just to see it sit in my garage for 2 months!
 

Sounds like a bad TPS or CPS (Throttle position sensor or crank position sensor) Is it jetting black smoke? If so an injector could be messed up and pouring fuel in.
 
Look on the bright side, when you do get her runing, you have all that new stuff...just trying to bring a little optimism your way.
 
Back
Top