Column Rebuild Problem

[silentdub]

Hey guys, I am helping a fellow jeep owner with a column rebuild.

The ignition lock was shot, ordered new, no big deal.

There is a gear attached to the back of the ignition lock that rides on the shaft that pulls on the ign switch. I NEED THAT GEAR!

I have done many GM rebuilds usually due to thefts and such, but does anyone have this gear? Where can I get it?

83 CJ, Non Tilt, Non Cruise, manual Trans.

Most places sell bearings and the lock, but not this piece. Have PAYPAL if anyone has it.

Thanks!

 

[silentdub]

Anyone have a source or part #?

 

[silentdub]

pic

 

[silentdub]

tttttttt

 

[silentdub]

trying to get 5 posts here to post a pic

 

[silentdub]

 

[silentdub]

sector gear, 9116N

I found the part for NON tilt columns.

Year One has a nice blow up in the tech section of a tilt and non tilt GM column.

The above part number is for the non tilt column.

 

[ursman]

The GM column is hella common and can be found in any junkyard. If you can get one out without boogerin' it up, I'd do that.