Search results

I am trying to fix a buddy's jeep that he drove off a 6' creek bank. The motor mount plate is bent very bad and I need to get the crank pulley off without damaging it. What puller will work?

Having installed the 5.3 in the 1988 YJ I am now focusing on the axles. I want to know about the Auburn ECTED, ARB and any other selectable lockers. Just need input to help with my choice.

After 8 months and 5700.00 and countless hours of fitting and fab work I finally got it running down the road. The guys at Novak Conversions are extremely helpful. Ken Brown and Eric are the guys to talk to. My knowledge is basic, I can change a motor and do basic mechanical stuff. This one was...

How do I determine weather a trans is a ax5 or an ax15?

Here I am again with more questions. I am basically rebuilding this whole jeep. Should I rebuild the 231 with stronger parts or get a different t-case? I am wanting a good t-case for the least amount of cash. What are my options? Thanks Keith

I scored an explorer rear end for 30.00 bucks!!!! 373 gears and posi lock just need calipers and rotors. Sweet deal. Now I just need to know how to install it. It has the electronic in the top. What do you do to the drive shaft? Where do you buy new spring perches and the other brackets? Is...

Will the axels out of a rubicon work on my 88 YJ? What kind of modification will be necessary to make it work? Keith

I just completed the "Nutter" bypass. The jeep works a hundred times better now. I am not sure I did the timing as correctly as it should have been done though. I just did not know the correct RPMs at idle. I also have a driveline vibration at 3000 RPMs but that is another issue. Anyway, Thanks...

I have an 88 YJ. I noticed that it had the wrong carb and put the correct computer controlled one back on. It is a new rebuild. The first carb was off a 74. I replaced the carb because the bowl gasket was leaking badly. Now it will not idle at all. It acts like the timing is off. What does the...