Search results

1054032 Starter or starter solenoid? Maybe loose connection.[addsig]

1054123 I think you got a bad alt. Did you test it at the battery. You can't always go by the gauge[addsig]

1054158 Try this diagram it may help! Vacuum Diagram[addsig]

1054515 It takes 6 quarts and maybe a 1/4 more with a new filter. Hey believe it or not some people don't change there oil filter every oil change.[addsig]

1054516 I ripped out my carpet, applied the 2 coats rubberized under coating to the floor, then installed new carpet set (124.00) with 1/2 inch padding from Quadratec. It made a big difference.[addsig]

1072713 Thanks, I check for a vent.[addsig]

1072714 Just a thought I changed my fan clutch and it still kept over heating until I read somewhere that there are 2 different fan clutches a regular one and one that says reverse on it. You may have put in the wrong clutch and not even known about it. I went back and forth the to auto parts...

1072774 My temp runs under 200 about 190-195. It never goes over 200.[addsig]

1072847 Replace the wires. sounds like you have a cracked wire somewhere. Also check the dist. for water or condesation. Remove the cap and load up the edge of the cap with dielectric grease to create a seal between the cap and dist.[addsig]

1072904 Sounds like your power steering pump is going. Make sure you have Power steering fluid in the pump.[addsig]

1072907 I have a weber and I have mine set At 8* BTDC[addsig]

1074496 On my 88 I just pryed off the plastic piece and there were 2 screws holding it on. I did not have to rmove the panel. Of course I remioved the panel first.[addsig]

1075597 It only works for the older 4.2 carburated jeeps. It bypasses the ignition module and eliminates the computer. It works great. If you do have a jeep that applys it is worth it. I would also recomend a Juice box. This is a higher voltage coil and bigger disributer cap and thicker spark...

1075601 I never seen a write up on belts. But you basically loosen the bolts and nuts on the Alt and power steering pump. Then you should be able to move the Alt and pump one way or the other and that will loosen up the belts to get them off. Then you can slip them over the fan if you still...

1076413 It almost sounds like the star wheels are not self adjusting. Whenever you back up the star wheels are supposed to adjust to the wear of the pads. If they don't adjust by themselves the brake shoes won't grab the drum to stop the wheels. They may stop initially when the brake is stepped...

1076876 I have had no problems with my Weber. There shouldn't be too many wires. Just about 3 or 4 wires to one clip for the stepper motor which will not be used and one wire with a connector on the end usually brown that will go to the electric choke. Unless you mistaking vacuums tubes for...

1076878 Try this site it may help you! Page title: Weber Install[addsig]

1076879 Do you guys leave your plugs out all the time? If so does water get in ?[addsig]

1077280 Some of the t-stats have weep holes that have to be in the correct position. It could be just a matter of repositioning the stat. Are you bleeding the system after you put it in. If you have air in the system it could overheat too. :-? [addsig]

1077457 Sorry but the correct way to check the oil is when the car had been off for awhile. 10 minutes is too soon for all the oil to drain back down into the drain pan. If you check it right after it has been running, there is still oil up throughout the engine. You won't get a correct...