Search results

Another issue is possibly security shut off. This happens when it doesn't read the key chip correctly (only in late 98 and newer) or if the security system is not functioning correctly and needs to be reset. Last possibility is fuel filter, pump, or pressure regulator. Sent from my SM-J320V...

List of possible issues (based on 2003 4.0L) 1 blown head gasket 2 clogged Cat or pre-Cat 3 bad o2 sensor 4 bad crank sensor (located under the timing cover near top) 5 clogged muffler (caused by bad Cat or pre-cat) 6 bad fuel pump 7 bad fuel injector(s) 8 bad spark coil tail 9 bad...

I would check with monster or some other energy drink. Sent from my SM-J320V using Jeepz.com mobile app

If on a 1999 - 2004 the tail light has an issue with the circuit board (alot), but if both are out then it is most likely a bad wire or the "light out sensor module" has gone out. Sent from my SM-J320V using Jeepz.com mobile app

I had to replace mine last year on a 2003 gc Laredo 4.0 (a week before it was totaled). Sent from my SM-J320V using Jeepz.com mobile app

The sensor on the transmission bell housing is for your tachometer not your crank. Sent from my SM-J320V using Jeepz.com mobile app

The blocks are different. For simplest examples compare alternator, spark plug connections, and exhaust systems. The newer version has: 1 more bolt points to allow newer plug system, 2 smaller exhaust ports to allow pre-cats to warm up faster, 3 alternator placement and wire system is...

If your having a vacuum issue and all of your Vac lines are good then you can get an aftermarket alternator for this jeep that has a vacuum pump built into it from orielys. Sent from my SM-J320V using Jeepz.com mobile app

Your maximum tire clearance is based on your fenders wheel well edge. Sent from my SM-J320V using Jeepz.com mobile app

Tj jeeps have always had an issue with fan switches melting. Find the common + On the switch and check it for power (a circuit tester will be needed for this, and can be purchased from Wal-Mart near automotive). If it has power then you will need to check each of the other wires at both the...

They are all pretty close to the same. I would just compare thickness and mounting options. Sent from my SM-J320V using Jeepz.com mobile app

If you already have the new fenders then I would: 1 remove the old 2 check for rust and repair 3 add "rock gaurd" stickers where new fenders will be 4 install new fenders 5 paint backside (inside) of wheel wells This should help to reduce and prevent any future rust problems. I would...

I have this problem a lot. I have already found out that it is my shift position sensor (neutral safety switch). Most of the time I can just while the shift lever a bit and it fixes it. The few times that this doesn't work I have to slide under the driver side of the car and smack the side fo...

In reply to the bad fan: You could also have a bad or loose connector on the blower resistor or even on the fan itself. I had this issue for a while until both fan and resistor finally went out and I replaced them both. Sent from my SM-J320V using Jeepz.com mobile app

Over all they are good for most suv type vehicles. Just make sure that you do the research on the specific flares that your going to use. Also I would recommend speaking with a rhino or line-x professional about options to help reduce the amount of possible "rub rust". Pros = Help to reduce...

I have this issue at times. If you put into reverse and allow jeep to roll while moving the 4x4 lever back and forth from 2x4 to 4x4 without really going all the way to 4x4 then it should "slip" into 2x4 mode. While doing this you may even have to turn your steering wheel as far to one direction...

On all jeep door latches (discovered from trial/error) I have found that if you disconnect the plug from the Switch it will turn off some light. If your done lights are still in then your headlight control switch needs to be checked if this doesn't fix it means that you have a broken wire...

I am needing help with my jeep lights. it has the fog and auto options i need the pinout and wire diagrams for this i work nights and need my car to work the problem came quick i was working and sitting on side of street holding brake pedal while in reverse and had headlight switch in auto mode...

I am needing help with my jeep lights. it has the fog and auto options i need the pinout and wire diagrams for this i work nights and need my car to work the problem came quick i was working and sitting on side of street holding brake pedal while in reverse and had headlight switch in auto mode...

I have a (sort of) specific issue. My jeep is a 1998 Grand Cherokee Limited (laredo with several limited features), 4.0L i6 and selec-track 4x4. The black wire harness on the back of my alternator gets really hot. As it heats up the total amps that my alternator put out drops. When not using...