Search results

1050701 I have the exact same set-up in my Jeep, except, for an AMC 360. I almost positive you are running lean. Rejet a COUPLE of sizes more rich. Also, When you installed the intake are you sure all gaskets lined up and went in right? [addsig]

1050827 44 would be better. But you would have to move the perches, in, to line up with your springs. While your doing this you can mount the perches spring over or spring under. Or put outside-of- frame spring hangers on the CJ. As far as the burned up bearings on your original axle, you...

1050828 Great, Is it narrow or wide? Is it complete? What is gear ratio, (if known)? Thanks [addsig]

1050933 Snitty, are you sure it is from a Cheer? That will not bolt in to a CJ... Check the distance from wheel mount surface to wheel mount surface, please. also, could you meas. the distance between the spr. perches. Thanks[addsig]

1051328 Your Jeep doesnt have points. So you should not concern yourself with those settings. Warm the engine unhook the Advance vacuume line on distr. and plug it. then set timing to correct specs, at the correct idle. [addsig]

1051329 You must TRY to rejet richer a couple of sizes. This corrected my prob. immediately. Is timing set right? [addsig]

1051511 Bad fuel pump or connections, check fuses, breakers or rollover switch [addsig]

1042017 Just let them break when removing, then replace with new bolts and anti-seize. It is the easiest way to do this.[addsig]

1042134 I run the Holley 4776, 600 cfm, double pumper on my 304 and 360, it runs great. It may not be too much flow that is causing your problems, rather, it may be a weak ignition. -joe[addsig]

1042136 What will you be using this vehicle for? Off-road or daily driver?[addsig]

1042216 What is a "tight clutch?"[addsig]

1042722 Did it work BEFORE you put in these new parts?[addsig]

1042758 What year and engine? Do you have power at the + side of coil when key is turned? [addsig]

1042760 Also, try taking off dist. cap. KEEP IT Out of the way, and turn eng. over. Is rotor turning? If it is, You can also pull off one plug wire stick an extra plug in it let tip of plug touch the engine, then turn key, does it have spark?[addsig]

1042763 Does it turn over? did you flush out all the fluids?[addsig]

1042809 did you geit it running yet?[addsig]

1042811 Please let us know what the prob. was. Thanks[addsig]

1043077 What kind of driving are you going to be doing?[addsig]

1043078 Ebay has them for cheap!![addsig]

1043079 That is all good, but I sent the pics in over a month ago! I will patiently wait. thanks -joe[addsig]