Search results

1062242 I have the same Nitros on my CJ 5, with 4" skyjacker lift. They were stiff for a couple of hundred miles but they get better. Had them three years now.[addsig]

1062243 Hey FISH, where you located? Are you selling it? What does it have in it? Thanks joeycj5@attbi.com :-O :-O :-O :-O [addsig]

1054775 Yea, I have a Master cyl/booster and prop valve off of a mid 80's wrangler. I just didnt know if it needs to be swapped or not.[addsig]

1054784 You mean there is a check ball in the M/C? Where is it? I will try anything before switching over Prop valve.[addsig]

1054791 I did find this page about the swap. http://www.jeepaholics.com/tech/mustangseats/mustangseats.htm :-O [addsig]

1054806 Did they end up sitting a lot higher than the stock seats.[addsig]

1054826 Hah? :-? [addsig]

1054929 What do they look like?[addsig]

1055012 AMC 360, T-18, 4.10's, and 33" BFG 2700 at 65mph :-P [addsig]

1055466 Like Dingus said, just get your diameter, and get a piece cut at a hardware or glass shop.[addsig]

1041711 I have almost the same set up in my CJ-5, 4" lift , 33" tires and 1" shackles. I think it drives pretty smooth. How much air psi are you runniing? I am at about 25 psi. [addsig]

1041713 I also have the '76 CJ-5, that had the T-150 & model 20 T/C. I swapped it out for a T-176 4 sp. & Dana 300 T/C, from the same donor vehicle. All I needed was a new clutch, a pilot bushing, a shorter rear driveshaft, and the longer front driveshaft from the CJ-7 donor vehicle. Now it...

1041714 As far as replacing the axles, it is pretty straight forward, take off tire, undo the rear brakes, and backing plate. You will need a slide hammer or puller to pop out the old AMC 20, 2-piece axle. WHen the axles are out, you must get your bearings pressed onto the new axles along...

1041862 Hey its a steal, like they said the lift motor and tires(if in good shape) is worth way more than that. The carb isnt a prob. either, a power valve can be repalced in 1/2 hour for under $20. [addsig]

1041912 I have pretty much the same set up in my cj-5, except, I haqve a 360. What type of valve covers do you have? Are they vented? [addsig]

1041935 YEA, that is what I thought you had. I have the same covers on my 360, it needs to be vented. I kept blowing the oil fill cap off of mine. Just take the covers off, and get, I think it was a 1" or 1-1/8" metal hole saw. pick a spot on top of the valve cover, and drill the hole in it...

1041936 Thanks, look for some of my pics!!!![addsig]

1041939 Yes, this definitely fixed MY problem. Actually, I only vented the one side and it worked, I bought the grommet and chrome breather cap at Advance Auto Parts, I believe they are Mr. Gasket parts, possibly Edelbrock parts. Make sure you use the right size hole saw, I don't remember the...

1051667 SSSNITTY!!!!!!!! where did you go? What do you have? [addsig]

1052836 My guess would be Driveline u-joints or rear end bearings! [addsig]