Search results

I need a Jeep T-176 or 177 4 speed either from Cj or Cherokee/ wagoneer. Need ASAP for a QUICK swap :cry:

Not many manual transmissions have a breather on them. :wink:

Hello "jhiggins" tell me about the driver side CJ fender you have!!! What kind of condition? How much??? Thanks

I have had good luck using the Skyjacker Nitro shocks. I bought them from WWW.4WD.com

I have had lockrights in my CJ with AMC 360 and 33" tires for three years.. With moderate to hardcore 4wheelin. Never a problem, have broke a couple of axles and driveshaft though!!! :roll: :roll: :roll: :roll:

Hey "rickcj5" do you still have that driver side front fender??? I tried to PM you, no response!!!!

Has anyon else lost the number of post they had listed under there name? I was near 100, now I am back to "0" :cry:

Is anyone going to the Canfield, OH 4wd jam this weekend? Also, does anyone know if the Rockcrawling course is going to be there this year? I received a couple of brochures, but no mention of the Rock course. :?

1045198 It is the master cylinder leaking, it cost $25, remove the two brake lines on the outside of M/C. Then remove the two bolts holding M/C. Disconnect the brake pedal linkage and remove old M/C. Replace with new, and bleed brakes again.[addsig]

1045199 I replaced the stock axle shafts with mosers, and replaced rear end gears with 4.10's. Runs great with 33's[addsig]

1063416 What transmission and T/C do you have? :-? [addsig]

1063988 How about the driver side fender? What condition is it in?[addsig]

1059361 Yes, they are the right pins. This set-up on the T-176, uses the two pins that are "pressed" in, actually pushed in, tight fit. Then you stick the safety wire into the pin holes and wrap it around like it shows in your photo. There is also a rubber boot that fits over top of this, it...

1059482 the new pins may be a bit oversized, I struggled to push them in place. Then the wire definetly keeps them there.[addsig]

1060004 Possible fuel filter, but an electric fuel pump has a check-valve in it so the fuel does not run back into the tank. These go bad, and cause hard starting, its main cause of fuel pump replacement. Next to complete pump failure. edited by: joeycj5, Mar 16, 2003 - 02:19 PM[addsig]

1060065 I am assuming you mean the wheel bearing grease. I have been using synthetic High Temp grease, only about $5.00 a can. It is high temp for disc brakes and completely waterproof.[addsig]

1060244 It depends on what kind of lube your looking for. But, "Summitracing.com" has the best pricing. :roll: [addsig]

1065847 It may, but it will burn up your alternater too. :-O [addsig]

1066423 Do you have a Driver side front fender? :-O [addsig]

1067256 $200 for both sets? You might as well buy them new. Hey SNITTY, you set up a rear end for the first time in UNDER an hour?????? :-O :-O :-O :-O :-O :-O :-O [addsig]