Search results

  1. O

    overheating...

    98 cherokee 4.0 so the wife gets upthis morning to go to school...comes in and asks if there is a such thing as getting so cold the heater doesn;t work...i say of course...is the jeep heating up? she says yes it;s in the middle...of course she;s a woman so i go to investigate... she takes my...
  2. O

    87 wrangler

    the engine has about 500 or so...but the odometer says 200k...it has low oil pressure for some reason...258 bored .060...i just can;t keep it runnin right and i'm tired of foolin with it...i think someone lookin for somethin to put a v8 in would be happier with this honestly
  3. O

    87 wrangler

    2500 hardtop...softop...new radiator...decent tires...i also have a brand new motorcraft to go with it and a set of stock wheels with no tires on it... in wilmington ohio just outside dayton... needs some work...
  4. O

    spider gear replacement...

    rear 87 wrangler... no big deal though...it was alot easier than i thought it would be...this is the first time i had ever done this...but when you get it apart it;s pretty straight forward...
  5. O

    spider gear replacement...

    well guys i got it out...but there were no c-clips...i had to unbolt a keeper from behind the breaks and slide the axles out...the tap out a roll pin...the carriere did have to come out to...i guess i could have tapped the roll pin out with it inside but i took it to work and smoothed out the...
  6. O

    spider gear replacement...

    either way it doesn;t sound to hard...
  7. O

    spider gear replacement...

    not even with jb weld...or duct tape...i have some epoxo 88... thanks...i'll give it a try this weekend...
  8. O

    spider gear replacement...

    how does one do this exactly... just by lookin at it...looks like i pull the axles out a bit to clear the carrier?then pull that out and remove the spider gears...and just the opposite to put them in...
  9. O

    FINALLY!!! The story continues...

    the scary thing is...they seem to worship him...
  10. O

    door frames

    full soft top door frames for an 87 wrangler... do tehy even exist?
  11. O

    Katrina Relief Work Report (lots of pics)

    that's really nice of ya...and if you were in moss point you were not far from my house...i used to hang out a little in moss point... they are actually ok...they had to stay with friends for a week or so but they are now back in their house...using tarps for a roof thoguh...i can;t...
  12. O

    Katrina Relief Work Report (lots of pics)

    just west of mobile alabama...aparently my highschool was so bad they decided not to reopen it again... exit 4 on interstate 10...
  13. O

    Katrina Relief Work Report (lots of pics)

    i'll be heading back home for the first time since it happened...my pa says you can still see the occasional boat in a tree...
  14. O

    GOOd lOOking GiRlS

    phoenix arizona... daytona beach...
  15. O

    gauges

    RE: 87 Cherokee 4wd not engaging nope...i looked and looked...shook wires lookin for a short...nothin... when i apply my brake sometimes my parking lights come on to... i have on or more shorts somewhere...just gotta find them...
  16. O

    gauges

    caster probs from 1" shackle lift? the likelihood of it being a gauge problem is small...since they all went nuts on me at one time...but i'll let ya know...
  17. O

    gauges

    you ever feel like your being followed yeah the speedo and tach work fine...i didn;t know about the corrosion...i'll check it out this weekend...
  18. O

    Barbara Streisand

    http://en.wikipedia.org/wiki/Category:Atlantic_hurricanes i heard somewhere...i dunno if it;s true or not really...but i heard that scientists believe hurricanes run in either 40yr cycles...and we are at the end of the light cycle and the storms will be more and more intense...
  19. O

    gauges

    RE: Re: Iditos In The News all my gauges are pegged out high...do they all shaer a ground somewhere? 87 wrangler...
  20. O

    this may sound stupid...

    RE: Re: RE: Hate to bash, but.... seems i found it guys...the bonding strap from the engine to the chassis had come loose...tightened up and it ran great...thanks for the info...
Back
Top