Search results

I used the same setup on my TJ today ... very easy and very quick install ... thanks for the link ...

I did the homemade disco thing a few minutes ago ... took me longer to get help finding the crap than it did to put them on ... $5 for parts and $4 for the torx bit .. about 10 min labor ... EASY :!: Is there anything I should be concerned about using this set-up :?: What do I do with the...

just took my radiator out tonight ...TJ radiators suck... guy is supposed to reseal it and rod it tomorrow ... $65 .. is that a good price? ..and sameday service included ... My jeep runs at about 210 degrees now ..will it get better and is that bad for the motor?

fuse box ...Use your rear wiper if you got a soft top

I cant be much help .. i just want to know how much you paid for the bearings .. Did you get the whole assembly? my bearings are past due .. i looked into it and at $150 per wheel I have to wait

Any one got a TJ link to do the diso's? .. im a tear it apart and glue it back together guy .. sounds fun

some deal .... 1 for the price of two .. but im a mud man ... its more forgiving on the ol' family truckster than rocks would be

Could be an EXHAUST LEAK .. my jeep sounds like a lifter is tapping till it warms up ... somehow the last bolt on the manifold got broken off by the previous owner and the manifold is now loose ... Do you have any power loss if you drive before it warms up ? Take it to a jeep dealer b/c i...

I seen a guy at school that has 22's with lo pros on a dang jeep ... what a waste

oh yeah...sand the edges with a palm sander after you cut the glass... high grit to just round it off with no sharp edges.... then just rub oil on the edge and make it look like a professional job.. it will be easier on the moulding... you could get them to cut it as a piece of glass with your...

I worked at a glass shop before and its pretty easy ... 1)all you do is get some LAMINATE glass and cut to match 2)take the moulding put it on the new glass... put some rope inside the groove where it is supposed to fit the windshield frame 3)put the glass on the outside of the frame...

MUD KINGS ... hwy only though .. my cousin runs the same off road and he says that they chip and get cuts too easy ..

I just put that on my jeep ... works great ... I got the setup from rusty's offroad for about $80 .. the bracket was 25-30 and the 6x9 filter was about 50 ... I sealed up all the holes in the wheel wells with some gasket seal and even the shock holes that where the most dirt gets in ... now my...

They will have to put up with lots of hwy miles ... DO 33x12.50's FIT ON 15x8 RIMS???... i see they dont sell 10.50..

RETREADS try taking out your shifter and check for those little spacers under the ball ...2nd went out on me before so i pulled the whole thing and let it sit up for about 6 mo. before i realized that all i needed was the $20 parts that had wore out ... my shifter was sitting too low in the...

I lost the link but those tires seemed pretty cheap .. $60 for 33's .. can you TRUST tires like that :?: .. anyone still got the link .. it was hi-tech retread i think..

I dont have the do anything with the shifter and 4wd lever?

Pine Barrens, NJ Do you have to make any mods to the automatics and A/C .. I have a TJ w/ 2" susp lift and want to get 2" spacers.... SYE is too expensive ... T/C drop seems cheap .. will it work?

I dont think we're going on the trip now ... the ol' lady pulled out the checkbook and poormouthed me .. so "no trip and no three-wheeler that doesnt run" .... women just dont understand do they ... I like sleeping on the couch, its a lot like camping... Id still like to see the pictures if you...

it only holds about 12 gal when i fill it up .... close to 13 if its on a slope.... i said extra 50 if i drive slow...