Search results

1074045 yep it worked, i used mobil 1 synthetic gear oil. now i just have to clean up the drive way..[addsig]

1074184 check any military base for the DRMO auctions[addsig]

1074185 i used the torx bit because i could not find the right hex bit, i went to 3 different auto parts stores in my neighborhood, and nobody had the right size bit. i was able to get the fill plug out with a locking vise grips. so i had to improvise with the torx on the drain plug[addsig]

1074186 what stores carry redline?[addsig]

1074222 1987 peugot trans, drain plug lower rear center. fill plug passenger side high up, center to rear..both of mine have a square indentation in them. they both match up with what is in the haynes, and chiltons books[addsig]

1074225 the hole is to small for a 3/8 and to big for a 1/4 [addsig]

1074354 i turn everything off, it might just be an urban legend but i thought that it wasn't good for the a/c compressor to turn it off by the key alone[addsig]

1074359 nypd[addsig]

1069960 my computer has been down for the past three weeks, i have the fender if still interested. and will check the code if still interested[addsig]

1069974 im going to have to take a screwdriver to the plug to clean out the crap first[addsig]

1070297 i did it i my driveway with a floor jack and a block of wood under the tranmission. it took about three hours of wedging and tugging but i got the job done on my own.[addsig]

1070305 i got my 87 for $800, and after replacing the intake and exhaust gaskets, changing all the fluids, motor mounts and giving it a tune up. it is running pretty good. but the main problem is that gremlin, the dreaded vacuum leak....my next project is to replace the clutch and the...

1070317 it was nice yesterday but i had to work a double. by the time i got off i could see the clouds rolling in and now it is raining again and my allergies are killing me...[addsig]

1070326 yes it has the peugot trans. that is the only other downside. when i blow that one up i will find an ax-15 and hook that up to the dana 300 transfer case i have lying around.[addsig]

1070334 how do you keep that thing running for over 400,ooo miles?[addsig]

1070340 subtract the time it took me to stop swearing at the frozen nut, trying to raise the engine to the right level, then lowering it to get the bolts back in. the the constant phone calls when i finally get into a grove..but those red daystar mounts look good. it might have taken me...

1070343 correction it is the hydraulic clutch release bearing that i need to replace[addsig]

1070344 i like the weber idea, but what can i do to keep my jeep emission legal? and get rid of that gemlin sitting on top of my intake manifold :-? [addsig]

1070369 i ended up going to chrysler and getting new nuts and bolts. i figured this should be the only time i take them off so i went with new ones[addsig]

1070553 now my question is: how did they get the jeep out and was the engine flooded?[addsig]