Search results

Well the welds that hold my control arm in place have broken (they were bent up in a previous accident). Do you guys think I should try and have it rewedded or just replace the axle? *see pics below for the carnage

I was thinks of doing some upgrades to my factory ignition system on my 1998 4.0 TJ as was wonder what you guys have done and what works and what doesn’t. I was thinking of getting an Accel coil (part no. 140021 ) and the nicer 8.8mm plug wires when I do my next tune up in a few days.

Lmao

Well here my two sense. When it comes to increasing HP I stick to the basics, trying to let the engine breath easier reduce internal friction better fuel delivery & a strong spark. The most bang for the buck so far has been the Intake (AEM).

Dude keep the lockers. 1st. They are really expensive (esp the selectable type)! 2nd. As long as there not "turned on" or "locked" they will cause you no problems (unless they were installed wrong). 3rd. If you plan to get more into 4 wheelin your jeep (tougher trails) you will be very, very...

Looks sweet!

I believe I read some where that the front calipers on a Grand Cherokees will fit on a TJ. The reason I'm interested in this is because the Grands Cherokees have a dual piston caliper (if I'm not mistaken) and the TJs only have a single piston. Is there really any benefit to this sort of swap if...

WOOO! Another TJ Guy! Welcome to the Jeep Side!

Welcome to the Jeep side:shades:!

Well they did the clutch service b4 we were together or I would of been all over it (I love to wrench when ever possible). Oh yeah I took it back to them told the "Asst Manager" what they did showed the +$800.00 work order and put on a good show ;). Went online and sent corporate a strongly...

Oh yeah, BTW they they charged her over $800 for the clutch service!

Today my gf's starter almost fell out of her bronco 2 (wouldn't start, made her late for work... yada, yada), she had the clutch replaced at Midas and they left the bolts loose, well actually they cross threaded one bolt in at an angle and left it in the bell housing sticking about an inch (got...

When you go buy parts from Napa, AutoZone, Checkers, Advance... and the guy behind the counter asks you "Is it a 4 wheel drive?" and you point out the window and reply "What do you think?"

Hmm, sounds like you have an air bubble in the cooling system. Try burping it.

Welcome!

hey if you want i'll take some pics of my 98 and post them so you can see what bolts go where if u get stuck....

Hmm, might be a good investment sense I'm in the market for a new set lol, the corner parts store has some generic cheapskates for about $9.00. Do you have a link or something SteelHeadz?

Compare the good one left, to the bad one right an y'all see what I mean the last pic I took w/ my crappy camera phone at work, u can kinda see how it was binding

Actually figured it out, when the old u-joint failed while driving it stretched out the retainer about 2 mils which was just enough to cause it to bind and rub the drive shaft yoke causing the vibration my front end dips down up and little at highway speeds.

ok guys will do thanks