Recent content by Nickg

Thank you

This for a 2.5L automatic

Im looking for the pin out diagram for a 95 jeep yj ecm connector. Does anyone have one or know where i can get one?

Re: Intermitent to no spark 95 wrangler Yeah it was an easy fix but it took a while to figure out cause every time i tested the starter it tested good

Re: Intermitent to no spark 95 wrangler It turned out my starter was having intermittent issues so it looked good was cranking great but was slowly dieing

Re: Intermitent to no spark 95 wrangler I got the sensor off, it was a pain to get off but it had a rubber grommit holding it in place. You had to pull out and when you pulled out it pops the grommit off. However when i replaced the crank sensor it didn't do anything the jeep still doesnt start

How did you get the crank sensor off? I cant get it off

Re: Intermitent to no spark 95 wrangler Anyone know how to get the crankshaft position sensor off? I have it unbolted but it has studs that go through it from the bell housing

No headway yet ive been. Usy with work havent gotten a chance to work on it yet

Its the 2.5l 4 cyl. And i like the cj hood so much better i dont lile the square headlights of the yj

Re: Intermitent to no spark 95 wrangler I did check all that im going to go through it all again

Thank you. Im gonna pick up a new sensor this week and try it out

Re: Intermitent to no spark 95 wrangler It is a 95 yj the previous owner took the hood off and put on i believe a 70's cj hood on it

Re: Intermitent to no spark 95 wrangler Thank you ive checked both and niether are bad. This issue has my mind boggled

Re: Intermitent to no spark 95 wrangler Thank you i have all good grounds there and the positive cable is good. The wires are all correct sizes