Recent content by 97wr@ngler

i have a 97 TJ with a 4 in lift and i have this vib at 60 mph it feels like the motor or even trans but any speed up to 60 is fine and after 60 is fine. anyone have any ideas?

I guess it depends on the size of the map

Use L brackets and self drilling screws and the amp I would put under that seat I would put it behind the back seat

It comes on as a warning to let u know u are almost out. If I didnt come on u would just run out and never know it

It's a 15 gallon

i am looking to do an axleswap and i was wondering is there a vehicle that i can pull one from and bolt it under my TJ?

i was wondering can u put dana 44 shafts in a 35 housing?

I just got done chatting with them and i was told I could put shims around the plate to drop it alittle more

No just square tubing to the frame they didnt weld the plate thankfully

I just had the plate off like an hour ago to replace the trans mount and while I was down there I played with the drive shaft and there was no wiggle room

4in Rough Country

just had a lift put on and they had to weld some square tubing along the frame where the belly pan is. my question is i have alittle vibration when shifting gears, can i shim the belly pan to drop the transmission alittle so there is not so much drive angle?

Oh he knew cause he had to drop the skid plate to lower the transfer case.

I had a 4in lift recently installed on my TJ and at no time did the mech's call me and mention that my transmission mount was shot, nor did they mention it when i picked it up the other day but when i went back to them they say "OH YEA FORGOT TO TELL YOU YOUR MOUNT IS SHOT" and when i asked them...

I just called the shop and they said they would look at it. thanks alot for the replies though i appreciate it.