Recent content by 2000roo

I am trying to fix a buddy's jeep that he drove off a 6' creek bank. The motor mount plate is bent very bad and I need to get the crank pulley off without damaging it. What puller will work?

I am running the ford 8.8 in the rear and the Dana 30 up front. I wa thinking about running a Spartan locker in the 30 and the ECTED in the rear because the cost of the cost of the ARB. I do not know anything about the OX. This is not a hard core Jeep. I only have 33's right now and might go to...

Having installed the 5.3 in the 1988 YJ I am now focusing on the axles. I want to know about the Auburn ECTED, ARB and any other selectable lockers. Just need input to help with my choice.

I am running the ax-15. It should hold up for a while then I plan to run the 4l60e.

I put a picture in my gallery.

1988 YJ with a 2002 5.3 Chevrolet V8 6" lift on 33's 4.56 gears

1988 YJ with a 2002 5.3 Chevrolet V8 6" lift on 33's 4.56 gears

After 8 months and 5700.00 and countless hours of fitting and fab work I finally got it running down the road. The guys at Novak Conversions are extremely helpful. Ken Brown and Eric are the guys to talk to. My knowledge is basic, I can change a motor and do basic mechanical stuff. This one was...

What kind of driveshaft shoul I use?

Another question. With the offset of the 8.8 is there going to be alot of drive line vibration on the highway?

How do I determine weather a trans is a ax5 or an ax15?

also, I am going with the x15 instead of the Peugeot. When I rebuild the tcase what input spline should I use?

I also just found out that I have to completely rebuild my D-30 front axle. Is it worth the rebuild? Remember cash is the problem. It needs ball joint and u-joints. So if I have to do that I might as well go through the whole thing. Input?

Here I am again with more questions. I am basically rebuilding this whole jeep. Should I rebuild the 231 with stronger parts or get a different t-case? I am wanting a good t-case for the least amount of cash. What are my options? Thanks Keith

It is the ABS sensor plug. All I have heard are positives about the swap. I picked up the rear end off Craigs list for 27.00 Yes, 27.00. I know that the calipers and rotors are 220.00 new. I thought that it wasn't a bad deal. I just know that my dana 35 is junk. I can lock up the 8.8 later. I...